Contemporary Glass Curio Cabinets

Glass Curio Cabinets: Awesome Artwork!

Hickory Cabinets Modern

Hickory Cabinets in Sophisticated Kitchen

May 12, 2016 Cabinets

How To Install Dresser Drawer Pulls

How To Install Dresser Drawer Pulls – dresser drawer pulls are pretty easy to install if all you need is one or two boxes that need to pull a tape measure and rafter square can be used to get the job done. When you work on several boxes a template or jig is handy for placing these holes in exactly the right spot every time.

Awesome Dresser Drawer Pulls

Awesome Dresser Drawer Pulls

Measure your dresser drawer pulls. Most have screws spaced 3 inches apart. Use a carpenter’s square and keeps pulling up to it, with the screw holes up for the most accurate measurement. Measure your drawer fronts from the top down. Cut a piece of 3/4-inch thick plywood as long and as wide as your shortest front. Use a square to mark a line down the center, from top to bottom and side to side, plywood piece. Continue up to the bottom mark on the edges of plywood on top and bottom. Divide the measurement from step one in half.

12 Inspiration Gallery from How To Install Dresser Drawer Pulls

Image of: Vintage Dresser Drawer Pulls
Image of: Unique Dresser Drawer Pulls
Image of: Old Dresser Drawer Pulls
Image of: Modern Dresser Drawer Pulls
Image of: Dresser Drawer Pulls
Image of: Dresser Drawer Pulls Kids
Image of: Dresser Drawer Pulls Antique
Image of: Dresser Drawer Pulls 2 Inch
Image of: Black Dresser Drawer Pulls
Image of: Best Dresser Drawer Pulls
Image of: Bedroom Furniture Dresser Drawer Pulls
Image of: Awesome Dresser Drawer Pulls
 

Cut two 1-of-2 lumber half the template is long to install dresser drawer pulls, 2 inches less on each bit. Apply glue along the top edge of the box face.  Mark the top edge of your box up in its center, side to side. Place the template, with 1-of-2 upper lip hanging up in the drawer front and resting on top of it. Clamp the template in place with two squeeze clamps and through the template and drawer face with a 1/8-inch piece into each hole. Remove the template and place the drawer pull to the front of the box face with the holes aligned with holes in the box face. Thread a screw through each hole from inside the box to the wires in the drawer pull. Tighten with a screwdriver.

READ  White Shaker Cabinets: Simple but Beautiful!
Incoming search terms: apothecary drawer pulls, dresser drawer pulls

Comments are closed.